PONTIAC 2008-2009 G8 2- Piece 3.5″ Aluminum Shaft with Center CV (Manual)

$1,489.97

SKU: 610160 Categories: ,
Description

Product Description

Available now for the 2008-2009 G8 is our 3-1/2 aluminum shaft with CV . We have done extensive testing with stock rears and with our 9″ kit and believe this to the the most cost effective trouble free drive shaft for the G8 available today. The shaft will come with our signature billet plates for each end so you done have to go in to the rear taking a chance on upsetting the crush collar (see below for billet plate VS changing to a Pinion yoke below) Our shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end (look closely at the CV end, its not all steel) The shaft only weighs 20lbs and come with grade 12.9 hardware with back up lock nuts to ensure no loose bolts. We have been using this Billet aluminum style plate for over 10 years on thousands of 1000+Hp Supras, BMW’s and many more without any bolt issues.

You will have to remove the heat shield from above center hanger mount to install a 3-1/2″ shaft and there is a possibility of clearance issues with aftermarket exhaust, This is a general warning, we have several test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested. (We also offer a Carbon fiber shaft is made from 3-3/8 and not the 3-3/4 like other manufacturers)

We have recently taken delivery of a new type balancing machine that can spin shafts to the actual speed (unlike almost every other balancer spinning only at 300-3500rpm)
click here for balance info

For anyone questioning the way the shafts mount with our billet plates
please click here for billet plate info billet plates VS billet yoke

Warranty: 1-year| Special Notes: 240MPH Max Speed.

Additional Information

Additional Information

Weight 40 lbs
Dimensions 71 × 7 × 7 in
length

68